Enterasys Networks CSX7000 Uživatelský manuál stáhnout pdf (Strana 596)

100

101

USER’S GUIDE

596 CyberSWITCH

Unable to prompt for device name at this time

Indicates that the

call

command would prompt you for a device name, but the necessary

resources are not available. The recommended actions are as follows:

1. If possible, enter the device name on the command line.

2. If the device name cannot be entered from the command line (for example, the device

name contains command line delimiters of a space, a comma, a colon, or a tab), the

device can wait for a few minutes and see if any resources become available.

3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,

please inform your service representative of the occurrence.

CALL DETAIL RECORDING COMMANDS

The following commands are used to monitor and verify the call detail recording (CDR) feature.

cdr stats

Display the CDR statistics. Refer to Call Detail Recording Statistics, for the available statistics and

corresponding definitions.

cdr stats clear

Clears the CDR statistics; setting them all to zero.

cdr verify

Generates a “verify” report to all servers that have been configured for CDR use, then typically

displays a list of all servers to which it sent the messages. If no log servers or events are

configured for CDR, it will report that no messages were sent.

Refer to Log Commands for the commands that will allow you to display or erase CDR log reports.

CALL RESTRICTION COMMANDS

When the Call Restriction feature is enabled on the CyberSWITCH, the following command is

available through the administration console:

cr stats

Displays the current Call Restriction statistics. Refer to Call Restriction Statistics, for a list of

available statistics and their definitions.

Other Call Restriction commands are available through Dynamic Management. Refer to

Configuring Call Control for these commands.

1 2 ... 591 592 593 594 595 596 597 598 599 600 601 ... 728 729

Komentáře k této Příručce

Žádné komentáře

Enterasys Networks CSX7000 Uživatelský manuál Strana 596

Komentáře k této Příručce