Enterasys-networks ROAMABOUT RBT-1602 Uživatelský manuál stáhnout pdf (Strana 41)

Mounting the Antenna

RoamAbout Antenna Site Preparation and Installation Guide 3-9

Tomounttheomni‐directionalbasestationantennatoamast,performthefollowingsteps:

1. Withthemountsituatedsothatthearrowsstampedonitstoothedsurfacefaceup,insertthe

topoftheantennathroughthecenterholeinthemount.

2. Slidethemountdowntheantennauntilitis

seatedsecurelyaroundthebaseoftheantenna.

3. Tightenthesetscrewsonthesidesofthemountuntiltight.

4. PlacetheU‐boltaroundthemast.

5. InserttheU‐boltendsthroughthescrewholesonthesideflangeofthemount.

6. Inserttheflatandspringlockwashersoverthe

U‐boltthreadedends.

7. ThreadahexnutoneachendoftheU‐boltuntileachnutisfingertight.

8. PositionantennaatdesiredlocationalongmastandtightenbothhexnutsusinganAllen

wrench.

9. Aftermountingtheantenna,connecttheantennacablesasdescribedin“Connectingthe

AntennaCables

”onpage 3‐34.

Note: The mount’s center hole is tapered to match the taper of the antenna base. The antenna will

thus fit snugly into the mount’s center hole.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 91 92

Žádné komentáře

Enterasys-networks ROAMABOUT RBT-1602 Uživatelský manuál Strana 41