Enterasys Networks VH-8TX1MF Uživatelský manuál Strana 36

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 54
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 35
22 Installation VH-8TX1UM/VH-8TX1MF
10Base-T/100Base-TX Ports
The 10Base-T/100Base-TX ports use RJ-45 connectors. Figure 2-4
shows an RJ-45 connector being inserted into a port.
Figure 2-4. Inserting an RJ-45 Connector into a Port
The ports on the base unit are wired with the MDI-X function
implemented. These ports interface to UTP cabling for
connection to
10Base-T or 100Base-TX network segments or end-stations.
These UTP
connections meet the requirements of ISO 8877, specified by 10Base-T,
Section 14 of the IEEE 802.3 specification. Workstations or servers can
be connected to these ports using standard straight-through wired cables.
For connections to other switches or hubs, use an MDI port on the other
device. If an MDI port is not available, a crossover
cable may be
necessary (refer to “
MDI/MDI-X Crossover Cable Wiring” in Appendix A).
See Table A-2, “10Base-T/100Base-TX Pinouts,” for 10Base-T/
100Base-TX connector pin assignments.
Zobrazit stránku 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

Komentáře k této Příručce

Žádné komentáře