Enterasys-networks Enterasys SecureStack B2 B2G124-24 Uživatelský manuál stáhnout pdf (Strana 37)

Installing the Switch on a Flat Surface

SecureStack B2 Installation Guide 3-7

Figure 3-3 Chassis Bottom, Rubber Feet Placement

4. Removethe protectivestripfromthe backofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeetintheotherthreelocations.

5. Afterinstallingthe rubberfeet,returntheswitchtoitsuprightposition.

6. Proceed

to“GuidelinesforFlatSurfaceInstallation”onpage 3‐8.Forarackmount

installation,proceedto“RackMountingtheSwitch”onpage 3‐9.

1 Bottom of chassis as seen when chassis is

resting on its back

3 Rubber feet with adhesive backing

(four)

2 Locations to install the rubber feet (four locations)

Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to

install the rubber feet on each switch before continuing with the installation.

ÂÂ

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Žádné komentáře

Enterasys-networks Enterasys SecureStack B2 B2G124-24 Uživatelský manuál Strana 37