Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4G428 Uživatelský manuál stáhnout pdf (Strana 87)

Gaining Access to Memory Modules

Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-9

Removing the DRAM SIMM

ToremovetheDRAMSIMM,refertoFigure B‐5andproceedasfollows.

1. RefertoFigure B‐5.PushtheconnectorarmsawayfromtheDRAMSIMMtoreleaseit

fromtheconnector.

2. RemovetheDRAMSIMMfromtheconnector.

Figure B-5 Removing the Existing DRAM SIMM

Installing the DRAM SIMM

ToinstalltheDRAMSIMM,refertoFigure B‐6andproceedasfollows:

1. Withtheconnectorarmssetintheopenposition,inserttheDRAMSIMMbetweenthe

connectorfingersandpushtheDRAMSIMMintotheconnectoruntilthetabsonthe

twoconnectorarmspullintowardstheDRAM

SIMMalignmentnotches.

2. PushtheDRAMSIMMfurtherintotheconnectoruntilthetwoDRAMSIMM

alignmentnotchesandthetabsonthetwoconnectorarmslocktheDRAMSIMMinto

place.

Note: The ejector arms on this connector are not spring-loaded, so they will remain in the

open position until manually closed.

1 Connector arms 2 Memory module 3 Connector

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones

de seguridad para evitar descargas de electricidad estática.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 99 100

Žádné komentáře

Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4G428 Uživatelský manuál Strana 87